🤰 Due Date Calculator

Estimate your due date, see how many weeks pregnant you are, and get every milestone date on one timeline. For planning only — your clinician's dating scan overrides it.

Pick a date to see your timeline. Dates are prefilled with a sample — replace them with yours.

How the due date is calculated

The standard method is Naegele's rule: take the first day of your last menstrual period (LMP) and add 280 days — 40 weeks. The arithmetic behind that number is a 28-day cycle with ovulation on day 14 plus 266 days of gestation: 14 + 266 = 280. If your cycle is not 28 days, this calculator shifts the estimate by the difference, so a 32-day cycle pushes the due date four days later, because ovulation is assumed to happen four days later.

If you know the conception date — from a tracked ovulation, an IUI or a single known encounter — choose that mode instead. It adds 266 days, which is the average interval from conception to birth, and back-calculates the "virtual" LMP so gestational age still lines up with how your chart is written.

Why pregnancy is dated from your last period

Gestational age starts about two weeks before you were actually pregnant. This is not an error — it is a convention that predates ultrasound, when the last period was the only reliable marker available. Everyone uses it: your chart, your scan reports, your test results, the week numbers in pregnancy apps. So at "8 weeks pregnant" the embryo is about 6 weeks old. Confusing at first, but consistent, which matters more.

How accurate is an estimated due date?

Only about 4% of babies arrive on the estimated date. Roughly 60% arrive within a week of it, either side, and the spread is wide: 37 to 42 weeks is all considered term. First pregnancies tend to run slightly longer than later ones, and the LMP method is inherently approximate because cycle length and ovulation timing vary from month to month.

A dating ultrasound between 7 and 13 weeks is more accurate than the LMP method, typically within about five to seven days, because embryos are nearly identical in size at that stage. Later scans are less useful for dating — by the third trimester normal size variation is measured in weeks. If a scan and this calculator disagree, use the scan; clinicians will re-date the pregnancy and the due date in your chart becomes the official one.

Reading the timeline

The result shows gestational age in weeks and days (the format on every scan report), the trimester, days remaining, and a milestone table. Those milestones follow the usual US schedule: the end of the first trimester at 13 weeks 6 days, the anatomy scan window at 18–22 weeks, the point of viability at about 24 weeks, the third trimester at 28 weeks, early term at 37 weeks and post-term at 42 weeks. Dates in the past are marked as passed — useful when you are catching up on records rather than planning ahead.

IVF and known-transfer dates

For IVF, count from the transfer rather than the period: a day-5 blastocyst transfer due date is transfer date + 261 days (266 − 5), and a day-3 transfer is transfer date + 263 days. Enter that computed date in "conception date" mode and the rest of the timeline follows.

Limitations

This tool assumes a regular cycle and a single pregnancy. Irregular cycles, recent hormonal contraception, breastfeeding, twins or more, and cycles shorter than 20 or longer than 45 days all widen the margin of error considerably. It does not read your scan, cannot detect complications, and is not a substitute for prenatal care. If you have bleeding, severe pain, reduced fetal movement or any worrying symptom, contact your clinician or emergency services rather than adjusting a date here.

Frequently Asked Questions

How accurate is a due date calculator?

It gives you the statistical midpoint, not a prediction. About 4% of babies are born on the estimated date, roughly 60% within a week either side, and anything from 37 to 42 weeks counts as term. A dating scan at 7–13 weeks is more accurate than any calculation from your period, usually within five to seven days, so treat the scan as the authoritative date once you have one.

Why does pregnancy count from my last period and not conception?

Because gestational age is a shared convention, not a measurement of the embryo. It starts roughly two weeks before conception, when the last period began. Every scan report, lab result and chart uses that clock, so "10 weeks pregnant" means about 8 weeks since conception. Keeping one convention avoids the confusion of two competing sets of week numbers.

What if my cycle is longer or shorter than 28 days?

Ovulation usually happens about 14 days before the next period, so a longer cycle means later ovulation. Set your average cycle length and the estimate shifts one day for every day away from 28 — a 32-day cycle moves the due date four days later, a 25-day cycle three days earlier. If your cycles vary by more than a week, rely on an early ultrasound instead of any calculation.

Can I use this after IVF or a known conception date?

Yes — choose "Conception date" mode. For a day-5 blastocyst transfer use the transfer date plus 261 days; for a day-3 transfer, plus 263 days. That accounts for the days the embryo already spent in the lab, which the 266-day conception interval does not.

🛒 Recommended for You

As an Amazon Associate, Benditools earns from qualifying purchases. This page is not medical advice — talk to your clinician before starting any supplement.